This in vitro study evaluated how rational selection of device resistance can be used to minimize flow rate dependence in dose delivery in vivo. Aerosol performance of amphotericin B inhalation powder was assessed using a Next Generation Impactor (NGI) at a range of pressure drops (1, 2, 4 and 6 kPa) with low, medium, high, […]
Archives
This paper focuses on the regulatory aspects of propellant switch programs for pressurized metered dose inhalers (MDIs) where products currently regulated by the United States Food and Drug Administration (FDA) are involved. Currently, several critical regulatory parameters and questions are yet to be decided upon by the FDA. There is much to be learned from […]
This article describes the development and validation of the Alberta Idealised Nasal Inlet (AINI), illustrating its use within existing test set-ups. It also discusses three experimental studies that demonstrate: 1) the ability of the AINI to capture in vivo deposition behavior for different nasal drug products, 2) use of the AINI to assess and optimize […]
We investigated how the change from current generation to next-generation pMDI propellants might affect the technical performance of currently used pMDI hardware, with a focus on actuator designs that assist with achievement of in vitro equivalence. The key finding of the preliminary in vitro studies described is that the changes required to convert pMDI formulations […]
In this opinion article, Inhalation talks with Alex Wilkinson and Gregor Anderson about aspects of a potential sustainability roadmap for inhalation platforms that could lead to reaching the UK’s National Health Service net zero goal. They believe that while new propellants are a major step forward, much more work must be done to meet this […]
An ex vivo study was designed to compare the dosing efficiency of different inhaler devices (soft mist inhaler [SMI], pressurized metered dose inhaler [pMDI] and dry powder inhaler [DPI]) and investigate their robustness to inhaler orientation. Stiolto® Respimat® SMI, Trimbow® pMDI, Fostair NEXThaler® DPI and Trelegy Ellipta® DPI were each tested using the Alberta Idealized […]
With the increasing prevalence and use of digital technologies applied to drug delivery devices and software solutions to support inhaled therapeutics, there are multiple considerations that patients, healthcare professionals, payors and pharmaceutical manufacturers can and should observe. Key considerations include identifying the stakeholders required, value to deliver to each stakeholder, system design and the laws […]
The SABINA study of SABA inhaler usage and risk of asthma exacerbations, funded by AstraZeneca, is the largest real-world observational data analysis of asthma inhaler therapy and has evaluated more than one million patients across 40 countries. In addition, at Queen Mary University of London, a study of more than 700,000 patient records evaluated SABA […]
The earliest reference to therapeutic dry powder inhalation may also be the earliest reference to “engineered particles,” dating from 1849, in London. An initial article looks at the history of dry powder inhalers, including devices and formulations, and discusses considerations for future DPIs. Then an interview takes a new look at current challenges and opportunities […]
The four parts of a dry powder formulation (the formulation, excipient, composition and processing) must be thoroughly understood in order to develop and optimize adhesive mixtures for inhalation. In addition, their interactions can be highly complex. This article gives examples and discusses the complex interaction between the formulation and the device. The articles in this […]
